Technical readiness of hot tubs

Before we bring your new hot tub home, there’s going to be a few things to think about.

The first relaxing bath is preceded by important steps, mostly technical in nature. With our little counselor, solving them won’t give you a single wrinkle.

It’s your hot tub – the choice of location is yours

We offer hot tubs suitable for exterior and interior. All have full insulation. This is suitable for outdoor use, but saves costs for indoor use as well.

Place the whirlpool pool on the ideal plane. The most suitable substrate is concrete, but other materials can be used after consultation with the dealer. Count on a load-bearing capacity of at least 500 kg, or depending on the type and size of the hot tub.

Leave about 50-60 cm of free spaceon each side of the hot tub . This is useful in the case of servicing, so that the technician can get to all the technology. The hot tub can also be located at the wall, but always leave an accessible side with the control panel.

All our hot tubs are suitable for in-ground installation

It is possible to start the hot tub partially or completely – that is, up to the acrylic.

The substrate must be paved, ideally concrete. However, always pay attention to perfect water equality. Consult the manufacturer for the thickness of the substrate.

We also leave space on each side forrecessed hot tubs . The technician can then access all technologies in the event of a service. Pay special attention to the side where the control panel is located.

Do not underestimate the preparations for the installation of the hot tub and always consult the manufacturer in detail.

Don’t forget about electrical readiness

For connection and installation of the pool, count on the recommended 400 V power supply with the 5Cx4 cable and the 20A-25A three-phase current protector. The equipment of the protector is governed by the input power of the whirlpool.

Make sure you consult the manufacturer when connecting the hot tub. Always leave the installation and connection to the electricity to the expert!

We’re filling (and draining) the hot tub for the first time!

Don’t look for a rooster on your new hot tub. Garden hosesare commonly used for filling .

Each whirlpool pool has a drain valvethat can be fitted with a hose. Hot tubs are usually discharged into drains or directly into the garden. In this case, it must have a suitable drain.

It is recommended to change the water in the hot tub at least 4 times a year.

If you have any doubts, please do not hesitate to contact us. We will be happy to explain everything to you.

This site is registered on wpml.org as a development site. Switch to a production site key to remove this banner.